Scroll Wheel Test

Roll your mouse wheel inside the box, slowly and then as fast as you can.

FreeNo sign-upPrivate

Scroll here
Roll the wheel up and down: slowly first, then as fast as you can.
Steps
0
Fastest
โ€“
Reversed or doubled
0
Uneven steps
0

Each bar is one step: up, down, reversed or doubled, uneven.

How to use the scroll wheel test

  1. Put the mouse pointer inside the box (the page itself won't scroll while it's there).
  2. Roll the wheel down: slowly for a few seconds, then faster, then flick it as hard as you can three or four times.
  3. Pause for a second and do the same upwards. Roll in one direction at a time rather than wiggling back and forth.
  4. Read the verdict. "Reversed or doubled" should be 0 on a healthy wheel; the bars show every step, so a fault is easy to spot. Press Reset to start again.

What this scroll wheel test checks

Most online mouse tests only count scroll clicks. That tells you the wheel works, not whether it works well. This test watches every step as it arrives and checks three things a failing wheel gets wrong:

It also shows how fast you can roll (steps per second) and how even the steps are, so you can compare a tired wheel with a new one, or a free-spin wheel with a notched one.

Why scroll wheels go wrong

Inside the wheel is a small rotary encoder: a wheel of metal contacts that opens and closes two switches as it turns. The order in which they open tells the mouse which way you rolled. Dust, worn plating and dried grease make the contacts bounce or miss, and a bounce in the wrong order reads as the opposite direction. That's why a wheel that "scrolls back on its own" or "skips" is almost always the encoder, not your software.

The encoders in most gaming mice are rated for a few hundred thousand detents. Heavy scrolling (long documents, Reddit, weapon switching) can wear one out in a year or two; it usually shows up first as occasional reverse steps at fast speeds, which is exactly what the fast roll in this test provokes.

How to fix a scroll wheel that skips or jumps back

  1. Rule out software. Try the wheel here, then in a second browser. If it only misbehaves in one app, it's that app's smooth-scrolling setting, not the mouse.
  2. Blow it out. Compressed air into the wheel slot, both sides, while rolling the wheel. Hair and dust around the encoder cause a surprising share of faults.
  3. Contact cleaner. Open the mouse, put a small amount of electrical contact cleaner (not WD-40) into the encoder's seam, roll the wheel a few hundred times, let it dry. This revives many encoders for months.
  4. Replace the encoder. Encoders cost a dollar or two (TTC and ALPS are the common brands) and are soldered with three pins. Match the height exactly: an 11 mm encoder in place of a 13 mm one leaves the wheel sitting low, and skipped detents are the result.
  5. Check the wheel seating. After any repair, make sure the wheel is pushed fully onto the encoder's D-shaped shaft and spins without wobbling; a wheel that is slightly off its axis skips detents too.

Reading the numbers

A notched wheel rolled by hand usually manages 15 to 30 steps per second in a hard flick; free-spin wheels (Logitech's hyper-fast mode, for example) go far higher and arrive in bursts. "Even" means each step arrived at about the same pace as the one before it, so speeding up or slowing down smoothly still counts as even, while sudden jumps don't: 85% or better is typical of a healthy wheel. Reversed and doubled steps should be zero; even one or two in a few hundred steps means the encoder is on its way out.

If the wheel is fine but the page still feels jumpy, check the mouse's polling rate and run the mouse button test; a double-clicking left button often turns up on the same tired mouse.

Frequently asked questions

It says my wheel scrolls smoothly rather than in notches. Is that bad?

No. Free-spin wheels, trackpads and some drivers send movements of all sizes instead of one per detent. Speed and reversed steps are still measured; missed and doubled detents can't be judged because there are no detents.

My mouse reports each notch as several small movements. Does that confuse the test?

No. Many mice and drivers use high-resolution scrolling, where one notch arrives as a quick burst of smaller pieces. Pieces that arrive within 10 ms of each other are merged into one step before anything is judged.

Does the number of lines per notch in Windows matter?

No. That setting changes how far each step scrolls, not how many steps arrive, and the test only counts steps.

Why does "uneven" go up when I roll slowly?

It shouldn't: uneven steps are only judged during fast, steady rolls. If you see them while rolling slowly, roll faster and watch whether the count keeps climbing.

Can this test a horizontal (tilt) wheel?

Tilting left and right is counted underneath the chart. Direction faults and speed are only analysed for the main up/down wheel.

Is anything uploaded?

No. The test runs entirely in your browser.